To Next PageTo Next PageWhat to do if my Kenroy Home Lighting bulb will not light?
If your Kenroy Home Lighting bulb won't light, there are several possible reasons. First, the bulb may be burned out, so replace it. Second, the power may be off; ensure the power supply is turned on. Third, the plug may not be fully inserted into the power outlet, so ensure it is properly inserted. Finally, the circuit breaker might be off, so make sure it is in the on position.
Why does the fuse blow when I turn on my Kenroy Home Lighting?
If the fuse blows or a circuit breaker trips when you turn on your Kenroy Home Lighting, it could be due to a couple of reasons. One possibility is that there is an exposed wire, in which case you should discontinue use of the lamp. Another reason could be that there are too many items on one circuit; try unplugging other items on the circuit.
General| Model Number | KH87050 |
|---|---|
| Bulb Type | Incandescent |
| Brand | Kenroy Home |
| Model | CHARLOTTE |
| Bulb Base | E12 |
| Voltage | 120V |
Read all instructions before assembly and prepare for installation.
Organize parts and assemble the poles for the floor lamp.
Connect the socket assembly to the top of the floor lamp pole.
Secure the harp to the lamp by inserting its ends into the holder.
Place the shade onto the harp and secure it with the finial.
Install bulb, check for silica packet, plug in, and turn on.
Screw the pole to the top of the base for the table lamp.
Pull cord through base and screw socket assembly to the pole.
Insert the harp ends into the harp holder.
Place shade onto harp and secure with finial.
Install bulb, check for silica, plug in, and turn on.
Details on the polarized plug and its safe use to reduce electric shock risk.
Clean the lamp with a soft, dry cloth; avoid chemicals or abrasives.
Solutions for common issues like bulb not lighting or circuit breaker trips.
