To Next PageTo Next PageHow to fix Kenroy Home Lighting if bulb will not light?
If your Kenroy Home Lighting bulb won't light, start by replacing the light bulb. If that doesn't work, make sure the power supply is turned on and that the plug is fully and properly inserted into the power outlet. Also, check that the circuit breaker is in the on position.
General| Brand | Kenroy Home |
|---|---|
| Model | JENKINS |
| Category | Home Lighting |
| Language | English |
Advise consulting a qualified electrician for any electrical questions.
Inspect wire insulation for defects before assembly; contact customer service if found.
Details what the warranty covers, excluding misuse, accidents, and improper installation.
Excludes damage from weathering, misuse, accidents, and consequential losses.
Read all instructions before assembly and assemble on a soft surface.
Lamp requires a 120V, 60Hz, 60-watt max, medium-base type A bulb.
Lists all parts included in the package with their descriptions and quantities.
Unpack and assemble the lamp pole by screwing the pole to the base.
Assemble the socket assembly by pulling the cord through the base and screwing it to the pole.
Assemble the harp by squeezing its legs and inserting them into the harp holder.
Assemble the shade by placing it onto the harp and securing it with the rubber washer and finial.
Install the bulb, remove silica packet, then plug in and turn on.
Details the polarized plug safety feature and how to handle plug insertion issues.
Clean the lamp using only a soft, dry cloth; avoid chemical cleaners.
Addresses issues where the bulb will not light, suggesting checking the bulb, power, and outlet.
Addresses fuse/breaker issues, suggesting checking for exposed wires or overloaded circuits.
