UF Process
KENT Ultra- Filtration is a separation process that uses a UF membrane with a pore size of 0.1-0.01 micron. This UF membrane has the capacity to remove
colloidal materials Including bacteria, cysts,s and even viruses from drinking water. Low applied pressure is therefore sufficient to achieve high flux rates from an
ultrafiltration membrane.
Auto-flushing System
The purpose of the Auto-flushing System Is to help prevent scaling or fouling of the RO membrane by providing a rapid rinse that washes away impurities from the
membrane’s surface and keeps the membrane clean. It of fees following benefits:
■ Lowers outflow of rejected water.
■ Improves TOS rejection rate i.e increases RO membranes efficiency.
■ Extends life of RO membrane.
Water Flow Diagram
S.NO. SPARE PART CODE ITEM DESCRIPTION
1 20011 SEDIMENT FILTER
2 20035 LOW-PRESSURE SWITCH
3 20012 ACTIVATED CARBON FILTER
4 20673 CARBON BLOCK 10″
5 20028 SOLENOID VALVE
6 20006 BOOSTER PUMP
7 20034 TDS CONTROL VALVE
8 20529 RO MEMBRANE
9 20018 FLOW RESTRICTOR TUBE
10 20004 OF MEMBRANE
11 20058 NON RETURN VALVE
12 20036 HIGH-PRESSURE SWITCH (HPS)
The above specifications are subject to modification for improvement without notice
Electrical Circuit Diagram
To Next Page
Loading...
Need help?
General
