Filter Change Alarm
KENT Elite Mineral RO™. Water Purifier has an in-built feature that sounds an audible alarm to indicate replacement time for filters. This alarm will be audible
after 700 hrs of use since the last filter change (or since the time of installation). The Filler Change Alarm will sound as following: 4 short beeps after every two
seconds, for 30 seconds. The alarm will repeat after every 2 hours of use.
In case such an alarm is audible please call the
service technician and request him to change the filters of the purifier. However, if the filters are not changed within the next 60 hours of opera lion, the purifier
stops functioning to ensure purity and hygiene. The following alarm will be audible after 60 Hrs. A continuous beep for an infinite time.
In case, such an alarm is audible, kindly switch off the purifier and call the service technician to replace the filters. In such a circumstance, the purifier will not
function unless the filters are changed.
Automatic Operation
■ The purifier automatically shuts off when the tank is full.
■ The purifier does not start when inlet water supply pressure falls below 0.3kg/cm2
■ The purifier automatically restarts when the water level drops below the maximum level
■ The purifier does not allow any water rejection in absence of electricity/when the tank is full
■ The purifier automatically flushes & cleans the RO membrane at periodic intervals
Installation Instructions
KENT Elite is designed to facilitate wall-mounting as well as counter-top purification. It is easy and convenient to install. Recommended Site Preparations:
■ Single-phase 100-250 V AC, 50-60 Hz. supply not more than 3m away from the point of installation
■ Raw water supply with ‘/2-inch nipple, not more than 3m away Drain for reject water not more than 3m away
■ Installation space as per the dimensions of the purifier
■ For proper installation, make sure that the purifier is mounted on a wall surface. Avoid installation on wooden and metallic stands
■ For optimum inlet pressure. source water tank should be at least 10 ft. above the purifier installed
Installation Procedure:
1. Screw-in two 10×50 self-tapping screws, 234 mm apart horizontally.
2. Wall-mount the purifier with the help of slot holes given on the backside.
3. Fasten the SS ball valve to the inch port of the 3-way connector.
4. Attach the threaded end of the 3-way connector to the raw water supply and plug off the other end or connect to a tap.
5. Now connect one end of the white pipe to the SS ball valve and
*Tested & Certified by TUV-SUD South Asia (P) Ltd.
the other end to the lower elbow titling connector is labeled as WATER IN, on the bottom of the purifier.
Use white pipe for raw water supply.
6. Connect one end of the blue pipe to the upper elbow fitting connector labeled as REJECT WATER and lead the other end to drain.
Use blue pipe for reject water.
7. Connect the purified water pipe to the watercooler.
8. Turn on the ever-given on SS ball valve to initiate the water flow to the purifier.
9. Allow the filters to pre-soak in the water for 2-3 minutes.
10. Connect the power supply.
11. Installation is complete.
When the water coolers storage tank gets filled up completely the float in the cooler will cut off the RO purified water supply from KENT Elite. This will further
create water pressure. In turn, the high-pressure sensor Installed in the machine will cut off the electric supply to the machine. The purification of KENT Elite will
automatically start again as soon as the water level drops.
TDS Adjustment
The unique TDS Controller enables customers to retain the contents of natural minerals in purified water. as per the requirement.
• Turning the screw of the valve anti-clockwise, results in an increased mineral content
To Next Page
Loading...
