Kenwood DPC-191 - Page 2

intenance
Simple care
Care of lens
When the lens in the pick-up gets dirty, malfunctions including the
impossibility of playback may occur. The lens should be cleaned
using a commercially available camera lens blower, etc. Do not touch
the lens to prevent damaging the mechanism. Also do not use a
jens cleaner or disc cleaner product.
Care of main unit
When the unit gets dirty, clean with a soft, dry cloth. If the unit is
stained seriously, a moistened cloth can be used. Do not use benzine
or thinner for these will damage the unit.
Cleaning the plug
Wipe the headphone plug with a soft cloth to keep it clean.
A dirty plug may cause noise or malfunction.
Caution on disc used
Usable discs
This unit is capable of playing discs marked with GB . Other discs cannot be played.
8 cm single CDs can be played as they are; do not use a commercially-available single CD
adapter.
Handling
Hold compact discs so that you do not touch the playing surface.
Do not attach paper or tape to either the playing side or the label side of compact discs.
Never play a cracked or warped disc.
During playback, the disc rotates at high speed in the player. Therefore, to avoid danger, never
use a cracked or deformed disc or a disc repaired with tape or adhesive agent.
Cleaning
If fingerprints or foreign matter become attached to
the disc, lightly wipe the disc with a soft cotton cloth
(or similar) from the center of the disc outwards ina
radial manner.
Storage
When a disc is not to be played for a long period of time, remove it from the CD player and store
it in its case.
Precaution against condensation
Immediately after a room is heated or in a room with high humidity (or vapor), the unit may
malfunction due to the condensation of dew or mist on the pick-up lens. In such a case, leave
the unit for about an hour before trying to use it again.
A\
Caution:
Read
this
page
carefully
to
ensure
safe
operation.
AC
adaptors
are
designed
for
operation
as
follows.
U.S.A. and Canada ...... AC 120 V only
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifica equipment may
cause
harmful
interference
unless
the
modifications
are
expressly
approved
in
the
instruction
manual.
The user could lose the authority to operate this equipment if an unauthorized change or modification is
made.
NOTE:
This
equipment
has
been
tested
and
found
to
comply
with
the
limits
for
a
Class
B
digital
device,
pursuant to Part 15 of the FCC Rules. These Jimits are designed to provide reasonable protection
against
harmtut
interference
in
a
residential
installation.
This
equipment
may
cause
harmful
interference to radio communications, if it is not installed and used in accordance with the
instructions.
However,
there
is
no
guarantee
that
interference
will
not
occur
in
a
particular
installation. if this equipment does cause harmful interference to radio or television reception, which
can
be
determined
by
turning
the
equipment
off
and
on,
the
user
is
encouraged
to
try
to
correct
the
interference by one or more of the following measures:
—- Reorient or relocate the receiving antenna.
~~ Increase the separation between the equipment and receiver.
—-—
Connect
the
equipment
into
an
outlet
on
a
circuit
different
from
that
to
which
the
receiver
is
connected.
—~ Consult the dealer or an experienced radio/TV technician for help.
For CANADA
Canadian IC Compliance Notice
NOTICE:
This
Class
B
digital
apparatus
meets
all
requirements
of
the
Canadian
interference-
Caussig
Equipment
Regulations.