Do you have a question about the Kenwood DPX-MP2100 and is the answer not in the manual?
maximum output power | 50 W x 4 |
---|---|
full bandwidth power | 22 W x 4 |
speaker impedance | 4 – 8 Ω |
tone action bass | 100 Hz ± 8 dB |
tone action middle | 1 kHz ± 8 dB |
tone action treble | 10 kHz ± 8 dB |
preout level / load | 2500 mV/10 kΩ |
preout impedance | ≤ 600 Ω |
frequency response | 20 Hz – 20 kHz |
---|---|
input maximum voltage | 1200 mV |
input impedance | 100 kΩ |
frequency range (50 kHz space) | 87.5 MHz – 108.0 MHz |
---|---|
frequency range (200 kHz space) | 87.9 MHz – 107.9 MHz |
usable sensitivity | 9.3dBf (0.8 μV/75 Ω) |
quieting sensitivity | 15.2dBf (1.6 μV/75 Ω) |
frequency response | 30 Hz – 15 kHz |
signal to noise ratio (MONO) | 70 dB |
selectivity | ≥ 80 dB |
stereo separation | 40 dB |
frequency range (9 kHz space) | 531 kHz – 1611 kHz |
---|---|
frequency range (10 kHz space) | 530 kHz – 1700 kHz |
usable sensitivity | 28 dBμ (25 μV) |
laser diode | GaAlAs |
---|---|
digital filter | 8 Times Over Sampling |
d/a converter | 1 Bit |
spindle speed | 1000 – 400 rpm (CLV 2times) |
frequency response | 10 Hz – 20 kHz |
total harmonic distortion | 0.008 % |
signal to noise ratio | 105 dB |
dynamic range | 93 dB |
mp3 decode | Compliant with MPEG-1/2 Audio Layer-3 |
wma decode | Compliant with Windows Media Audio |
aac decode | AAC-LC ".m4a" files |
operating voltage | 14.4 V |
---|---|
current consumption | 10 A |
installation size | 178 x 100 x 155 mm |
weight | 1.55 kg |