Need help?Do you have a question about the Kenwood DPX-MP7050 and is the answer not in the manual?
FM Tuner Section| frequency range (50 kHz space) | 87.5 MHz – 108.0 MHz |
|---|---|
| frequency range (200 kHz space) | 87.9 MHz – 107.9 MHz |
| usable sensitivity (S/N = 30dB) | 9.3 dBf (0.8 µV/75 Ω) |
| quieting sensitivity (S/N = 50dB) | 15.2 dBf (1.6 µV/75 Ω) |
| frequency response (±3.0 dB) | 30 Hz – 15 kHz |
| signal to noise ratio (MONO) | 70 dB |
| selectivity (±400 kHz) | ≥ 80 dB |
| stereo separation (1 kHz) | 40 dB |
AM Tuner Section| frequency range (9 kHz space) | 531 kHz – 1611 kHz |
|---|---|
| frequency range (10 kHz space) | 530 kHz – 1700 kHz |
| usable sensitivity (S/N = 20dB) | 28 dBµV (25 µV) |
Cassette Player Section| tape speed | 4.76 cm/sec |
|---|---|
| wow & flutter (WRMS) | 0.08 % |
| frequency response (70 µs) | 25 Hz – 22 kHz (±3 dB) |
| separation (1 kHz) | 40 dB |
| signal to noise ratio (Dolby NR OFF) | 60 dB |
| signal to noise ratio (Dolby B NR ON) | 68 dB |
Audio Section| maximum output power | 50 W x 4 |
|---|---|
| full bandwidth power (at less than 1% THD) | 23 W x 4 |
| preout level | 1500 mV/10 kΩ |
| preout impedance | ≤ 600 Ω |
Auxiliary Input| frequency response (±1 dB) | 20 Hz – 20 kHz |
|---|---|
| input maximum voltage | 1.5 V |
| input impedance | ≥ 68 kΩ |
General| operating voltage (11 – 16V allowable) | 14.4 V |
|---|---|
| current consumption | 10 A |
| installation size (W x H x D) | 178 x 100 x 155 mm |
| weight | 3.0 kg |
To Next Page