Do you have a question about the Kenwood GX-201KEF2 and is the answer not in the manual?
Steps and conditions to put the mechanism into transport mode.
Details pin assignments, I/O, and operations for the main microcontroller.
Explains the audio security system, its release, and confirmation process.
Details Code Confirmation, Non-Registration, and Delete modes for security.
Lists parts for the synthesizer unit with part numbers and destinations.
Lists components for the switch unit with part numbers and destinations.
Details resistor part numbers, values, and wattage.
Lists diodes and transistors for various units.
| FM Frequency Range | 87.5~108.0MHz |
|---|---|
| FM Channel Space Selection | 50kHz |
| FM Usable Sensitivity (S/N=26dB) | 6dBµV EMF |
| FM Signal to Noise Ratio (MONO) | 65dB |
| FM Selectivity (±300kHz) | 90dBµV EMF |
| FM Stereo Separation (1kHz) | 30dB |
| MW Frequency Range | 531~1611kHz |
| LW Frequency Range | 153~281kHz |
| MW Channel Space Selection | 9kHz |
| MW Usable Sensitivity (S/N 20dB) | 33dBµV EMF |
| LW Usable Sensitivity (S/N 20dB) | 40dBµV EMF |
| Tape Speed | 4.75cm/sec (+3%, -1%) |
|---|---|
| Wow & Flutter (WRMS) | 0.35% |
| Tape Stereo Separation (1kHz) | 35dB |
| Tape Signal to Noise Ratio (Dolby NR OFF) | 45dB |
| Tape Signal to Noise Ratio (Dolby BNR ON) | 48dB |
| CD Frequency Range | 87.5~108.0MHz |
|---|---|
| CD Channel Space Selection | 100kHz |
| CD Usable Sensitivity (S/N=30dB) | 6dBµV EMF |
| CD Signal to Noise Ratio (MONO) | 65dB |
| CD Selectivity (±300kHz) | 90dBµV EMF |
| CD Stereo Separation (1kHz) | 25dB |
| CD Digital Filter | 8 Times Over Sampling |
| CD D/A Converter | 1Bit |
| CD Total Harmonic Distortion | 0.5% (1kHz, 20kHz) |
| CD S/N Ratio | 60dB (1kHz) |
| CD Channel Separation | 50dB (1kHz) |
| Maximum Output Power | 20W x 4 (4Ω) |
|---|---|
| Bass Tone Action | 100Hz . ±8dB |
| Treble Tone Action | 17.5kHz . ±8dB |
| Operating Voltage | 13.2V (10.8~15.6V) |
|---|---|
| Current Consumption | 10A |












Loading...