To Next PageTo Next Page
Need help?Do you have a question about the Kenwood KFC-W2505 and is the answer not in the manual?
General| Size | 10 inch |
|---|---|
| Power Handling (Peak) | 1000 Watts |
| Power Handling (RMS) | 300 Watts |
| Impedance | 4 Ohms |
| Type | Subwoofer |
| Voice Coil | 2 inches |
Warning about plastic bags causing suffocation risk to children.
Connect speakers with illumination to 12V DC, negative ground.
Avoid installing speakers in damp locations.
Do not install speakers in dusty or unstable places.
Do not open or modify the unit to prevent fire or malfunction.
Clean speakers with a soft, dry cloth; avoid solvents.
Immediately turn off power and contact dealer if smoke or abnormal smell occurs.
Cautions to prevent speaker damage from high volume or operation during playback.
Check space with template, keep wiring away from noise/short circuits.
List of tools needed for installation, including drill, cutter, knife, screwdriver.
Install in boot or rear deck, avoid contact with springs, fuel lines, or glass.
Choose location based on 'Mounting locations' section.
Use template to mark, cut large hole, and make screw holes.
Peel protective sheet and attach spacer to speaker flange.
Install the unit as shown in the figure.
Connect speakers in series, total impedance is sum of individual impedances.
Connect speakers in parallel, total impedance is calculated by formula.
Combined series and parallel connection for multiple speakers.
Use a crossover network with an appropriate cut-off frequency.
Set amplifier sensitivity to match pre-output volume of CD player or Tuner.
Recommended dimensions and response curves for ported enclosures.
Recommended dimensions and response curves for sealed enclosures.
Recommended ported enclosure volumes and response graphs.
Recommended sealed enclosure volumes and response graphs.
Recommended volumes for ported enclosures and their frequency response.
Recommended volumes for sealed enclosures and their frequency response.
Formula to calculate enclosure volume in cubic feet using dimensions.
Product is warranted for one year from the date of original purchase.
Details what is covered and what is not covered by the warranty.
Steps to follow for warranty service and required documentation.
Limitations on implied warranties and exclusion of certain damages.
