Do you have a question about the Kenwood KMD60X19 and is the answer not in the manual?
Read all instructions carefully before use and retain the manual for future reference.
Appliance for indoor household use, away from heat sources and direct sunlight.
Ensure accessible plug, replace damaged cable, and manoeuvre unit with 2 persons.
Guidelines for children aged 8+ and reduced capability persons; supervision required.
Select a flat, firm, well-ventilated location, avoiding heat sources and direct sunlight.
Adjust the two levelling feet at the front to ensure proper door and seal alignment.
Ensure 25mm side, 50mm rear, and 25mm top clearance for optimal door opening.
Wipe interior with bicarbonate soda solution and exterior with a damp cloth.
Turn on the unit and wait 24 hours before loading food to reach correct temperature.
Diagram illustrating the main unit and its various components.
Connect mains, use electronic panel to set fridge (2-8°C) and freezer (-14 to -22°C) temperatures.
Cycle through modes: ECO, Holiday, Super Freeze, User Defined using the MODE button.
Energy saving mode; automatically sets fridge to 5°C and freezer to -18°C.
For periods away; automatically sets fridge to 17°C. Do not store food in fridge.
The internal LED light is not user-replaceable; contact a qualified service agent.
Hold the unit by its sides or base when moving; do not lift by the top surface edges.
Servicing by an authorised engineer is required; do not attempt self-repair.
Disconnect, empty, clean, and leave the door ajar to prevent unpleasant smells.
Condensation may appear outside due to room temperature changes; wipe off moisture.
Dispose of the unit environmentally, recovering materials and following special refrigerant procedures.