To Next Page
H
Heather Salazar MDSep 23, 2025
What does “NO SKIPS” mean on my Kenwood Car Receiver?
- SSheila JohnsonSep 23, 2025
The “NO SKIPS” message on your Kenwood Car Receiver indicates that the skip limit has been reached.
What does “NO SKIPS” mean on my Kenwood Car Receiver?
The “NO SKIPS” message on your Kenwood Car Receiver indicates that the skip limit has been reached.
What to do if my Kenwood Car Receiver says “MISWIRING CHECK WIRING THEN PWR ON”?
If your Kenwood Car Receiver displays “MISWIRING CHECK WIRING THEN PWR ON”, turn the power off. Check to ensure the terminals of the speaker wires are properly insulated, then turn the power back on.
What to do if there is no sound from my Kenwood Car Receiver?
If you cannot hear sound from your Kenwood Car Receiver: * Adjust the volume to the optimum level. * Check the cords and connections.
Why is sound being interrupted during playback of a Bluetooth audio player on my Kenwood Car Receiver?
If the sound is interrupted or skipped during playback of a Bluetooth audio player on your Kenwood Car Receiver: * Reduce the distance between the unit and the Bluetooth audio player. * Turn off, then turn on the unit and try to connect again. * Consider that other Bluetooth devices might be trying to connect to the unit.
What to do if my Kenwood Car Receiver is showing “PLEASE EJECT”?
If your Kenwood Car Receiver displays “PLEASE EJECT”, reset the unit. If the problem persists, consult your nearest service center.
Why is my Bluetooth device not being detected by my Kenwood Car Receiver?
If no Bluetooth device is detected by your Kenwood Car Receiver: * Search from the Bluetooth device again. * Reset the unit.
What does “NO INFO”/“NO DATA” mean on my Kenwood Car Receiver?
If your Kenwood Car Receiver displays “NO INFO”/“NO DATA”, it means that the Bluetooth device cannot get the contact information.
What does “CODE ERROR” mean on my Kenwood Car Receiver?
If your Kenwood Car Receiver displays “CODE ERROR”, make sure you have entered the correct pass code.
What does “USB HUB IS NOT SUPPORTED” mean on Kenwood Car Receiver?
If your Kenwood Car Receiver displays “USB HUB IS NOT SUPPORTED”, it means that the unit cannot support a USB device connected via a USB hub.
How to fix voice calling issues on Kenwood Car Receiver?
If voice calling method is not successful on your Kenwood Car Receiver: * Use voice calling method in a quieter environment. * Reduce the distance from the microphone when you speak the name. * Make sure the same voice as the registered voice tag is used.
Critical safety information regarding battery hazards and attention while driving.
Starting playback and connecting devices.
Preparation, listening, and basic controls for Pandora.
Preparation, listening, and basic controls for iHeartRadio.
Setup, ID check, and subscription for SiriusXM.
Searching and storing SiriusXM stations.
Starting listening and using channel/replay keymodes.
SmartFavorites, TuneStart, and TuneScan.
Connection, profiles, codecs, and microphone.
Steps to connect a device for the first time.
Auto-pairing and handling incoming calls.
Managing calls and improving audio.
Overview of calling, phonebook, and history.
Using voice for calls and storing contacts.
Adjusting speaker size and crossover parameters.
Fine-tuning DTA parameters.
Safety precautions and primary installation procedures.
Wiring details for KDC-X301/KMR-D368BT.
Wiring details for KDC-BT21/KDC-MP368BT.
General| Brand | Kenwood |
|---|---|
| Model | KMR-D368BT |
| Category | Car Receiver |
| Language | English |
