Need help?Do you have a question about the Kenwood kr-6340 and is the answer not in the manual?
Details on connecting speakers to "A" and "B" terminals.
Procedure to align speaker phase for correct sound output.
Connecting FM and AM antennas for optimal reception.
Connecting record players, tape recorders, AUX, and DIN.
Details Signal meter, Power switch, Phones jacks, Speakers switches, Mode switch, and Tone controls.
Details Volume, Amplifier Mode Lamp, FM Muting, Loudness, Tape Monitor, Tuning, Selector, and Balance controls.
Operation of AMP CONTROL for 4CH and 2CH modes.
Step-by-step guide for tuning and operating FM radio.
Step-by-step guide for tuning and operating AM radio.
Instructions for playing records using the PHONO input.
Instructions for connecting and operating tape recorders, including monitoring and playback.
Procedures for playing CD-4 discs with KCD-2 optional unit.
Guidance on transistor care for optimal performance.
Explanation of the protection circuit and its function.
Information on preventing howling sound caused by feedback.
Instructions for selecting AC voltage and replacing the power fuse.
Advice on safe cleaning methods for the receiver surface.
Common problems and corrections for AM reception.
Common problems and corrections for FM reception.
Troubleshooting no sound, unbalanced sound, or noise during playback.
Troubleshooting common problems during phono playback.
Details on connecting speakers to "A" and "B" terminals.
Procedure to align speaker phase for correct sound output.
Connecting FM and AM antennas for optimal reception.
Connecting record players, tape recorders, AUX, and DIN.
Details Signal meter, Power switch, Phones jacks, Speakers switches, Mode switch, and Tone controls.
Details Volume, Amplifier Mode Lamp, FM Muting, Loudness, Tape Monitor, Tuning, Selector, and Balance controls.
Operation of AMP CONTROL for 4CH and 2CH modes.
Step-by-step guide for tuning and operating FM radio.
Step-by-step guide for tuning and operating AM radio.
Instructions for playing records using the PHONO input.
Instructions for connecting and operating tape recorders, including monitoring and playback.
Procedures for playing CD-4 discs with KCD-2 optional unit.
Guidance on transistor care for optimal performance.
Explanation of the protection circuit and its function.
Information on preventing howling sound caused by feedback.
Instructions for selecting AC voltage and replacing the power fuse.
Advice on safe cleaning methods for the receiver surface.
Common problems and corrections for AM reception.
Common problems and corrections for FM reception.
Troubleshooting no sound, unbalanced sound, or noise during playback.
Troubleshooting common problems during phono playback.
General| Frequency response | 20Hz to 20kHz |
|---|---|
| Total harmonic distortion | 0.5% |
| Damping factor | 30 |
| Input sensitivity | 2.5mV (MM), 150mV (line) |
| Output | 150mV (line) |
| Speaker load impedance | 4Ω to 16Ω |
| Type | Stereo receiver |
| Signal to noise ratio | 90dB (line) |
To Next Page
