●
T
o release the maximum flavour and essential oils whole spices
are best roasted prior to milling.
●
Cut ginger up into small pieces before processing.
●
F
or best results the mini bowl attachment is recommended when
chopping herbs.
ds
citrus juicer (if supplied)
U
se the citrus juicer to squeeze the juice from citrus fruits (eg
o
ranges, lemons, limes and grapefruits).
a cone
b sieve
to use the citrus juicer
1
Fit the detachable drive shaft and bowl onto the power unit.
2 Fit the sieve into the bowl - ensuring the sieve handle is locked
into position directly over the bowl handle
bt
.
3 Place the cone over the drive shaft turning until it drops all the
way down
ck
.
4 Cut the fruit in half. Then switch on and press the fruit onto the
cone.
●
The citrus juicer will not operate if the sieve is not
locked correctly.
●
For best results store and juice the fruit at room temperature and
hand roll on a worktop before juicing.
●
To help with juice extraction move the fruit from side to side
when juicing.
●
When juicing large quantities, empty the strainer regularly to
prevent the build up of pulp and seeds.
dt
metal juice extractor (if supplied)
Use the centrifugal juicer for making juice from firm fruit and
vegetables.
a pusher
b lid
c pulp remover
d filter drum
e bowl
f juicing spout
g juice extractor drive adaptor
to use the juice extractor
1 Fit the drive adaptor onto the power unit
cl
– push down lightly
to ensure the adaptor is located correctly.
2 Then fit the bowl. Place the handle towards the back and turn
clockwise until it locks
cm
.
3 Place the pulp remover into the filter drum - ensuring the tabs
locate with the slots in the bottom of the drum
cn
.
4 Fit the filter drum
co
.
5 Place the attachment lid onto the bowl, turn until it locks and the
feed tube sits over the handle
cp
. Your juice extractor will
not operate if the bowl or lid are not fitted correctly
into the interlock.
6 Place a suitable glass or jug under the juice outlet.
7 Cut the food to fit the feed tube.
8 Select Auto and push down evenly with the pusher - never put
your fingers in the feed tube. Process fully before adding
more.
●
After adding the last piece, let the juice extractor run for a further
30 seconds to extract all the juice from the filter drum.
s
afety
●
Do not use the juice extractor if the filter is
damaged.
●
O
nly use the pusher supplied. Never put your fingers in the feed
tube. Unplug before unblocking the feed tube.
●
Before removing the lid, switch off and wait for the filter to stop.
important
●
I
f the juice extractor starts to vibrate, switch off and empty the
pulp from the drum. (The juice extractor vibrates if the pulp
becomes unevenly distributed).
●
M
aximum capacity that can be processed at one time is 1Kg of
fruit or vegetables (refer to speed chart).
●
Some very hard foods may make your juice extractor slow down
o
r stop. If this happens switch off and unblock the filter.
●
Switch off and clear the pulp collector regularly during use.
h
ints
●
B
efore processing remove stones and pips (eg pepper, melon,
plum) and tough skins (eg melon, pineapple). You don’t need to
peel or core apples and pears.
●
Use firm, fresh fruit and vegetables.
●
To maximise juice extraction place small quantities at a time in
the feed tube and push down slowly.
●
Citrus fruit - peel and remove the white pith, otherwise the juice
may taste bitter. For best results use the citrus juicer.
dl
attachment storage box
Your food processor is supplied with a storage box for your bowl
attachments and discs.
1 Fit the knife blade and discs into the storage box when not in
use
cq
.
2 The storage box is fitted with a safety lock - close the lid to lock.
To open, push the tab in
cr
and lift up the lid
cs
.
care & cleaning
●
Always switch off and unplug before cleaning.
●
Handle the blades and cutting discs with care - they
are extremely sharp.
●
Some foods may discolour the plastic. This is perfectly normal
and won’t harm the plastic or affect the flavour of your food. Rub
with a cloth dipped in vegetable oil to remove the discolouration.
power unit
●
Wipe with a damp cloth, then dry. Ensure that the interlock area
is clear of food debris.
●
Don’t immerse the power unit in water.
●
Store excess cord in the storage area at the back of the power
unit
ct
.
blender and compact chopper/grinder
1 Empty the goblet/jar, unscrew the blade unit by turning to the
unlock position to release.
2 Wash the goblet/jar by hand.
3 Remove and wash the seals.
4 Don’t touch the sharp blades – brush them clean using hot
soapy water, then rinse thoroughly under the tap. Don’t
immerse the blade unit in water.
5 Leave to dry upside down.
13