Need help?Do you have a question about the Kenwood NX-1700N-C and is the answer not in the manual?
General| Frequency Range | 136-174 MHz |
|---|---|
| Power Output | 5W |
| Ingress Protection | IP54 |
| IP Rating | IP54 |
| MIL-STD | MIL-STD-810 C/D/E/F/G |
| Display | LCD |
| Signaling | DTMF |
| Audio Output | 1 W |
| Operating Temperature | -30°C to +60°C |
| General Features | GPS |
| Emergency Features | Emergency Call |
| Modulation | FM |
| Channels | 128 |
Details on connecting the DC power cable to the transceiver and vehicle battery.
Identification and function of controls on the front panel of the transceiver.
Procedure for turning the transceiver power on and off.
How to increase or decrease the audio volume using the designated buttons.
Steps to navigate and select different zones and channels on the transceiver.
Overview of operating modes based on dealer-programmed functions assigned to buttons.
How to access and configure transceiver functions through the menu system.
Procedure to enter the correct password to unlock the transceiver when it is password protected.
How to temporarily remove channels from the scan sequence during scanning.
Methods for initiating DTMF calls, including manual dialing and keypad auto PTT.
Procedure for storing and sending DTMF numbers.
Functionality of stun codes for lost or stolen transceivers.
How to switch the transceiver to secure or encrypted transmission modes.
Procedure for choosing and setting the scrambler code for transmission.
How QT/DQT tones allow ignoring calls from other parties on the same channel.
How to reprogram QT/DQT tones using the OST List.
How RAN signaling in NXDN allows ignoring calls with unmatched RANs.
Color Code in DMR protocol for smooth communication on shared channels.
How 2-tone signaling opens squelch only for calls with matching 2-tone signals.
How 5-tone signaling is used for Selcall, Group Call, and Status Call.
How DTMF signaling opens squelch only for calls with matching DTMF codes.
MDC-1200 signaling system using Audio Frequency Shift Keying (AFSK).
FleetSync signaling opens squelch for calls matching FleetSync IDs.
NXDN ID signaling system available for digital communications.
How to make voice calls to stations or groups using FleetSync Selcall.
Making Selcalls, Group Calls, and Status Calls using consecutive 5 single tones.
Function to prevent extended channel use by stopping transmission after a set time.
Display of received call signal strength levels.
Audio announcements for zone, channel, and function setting changes.
To Next Page