How to fix Kenwood Portable Radio battery not charging?
To resolve a battery issue with your Kenwood Portable Radio, try recharging the battery pack. If the problem persists, consider replacing the batteries.
What to do if Kenwood TH-D7A Portable Radio is in Lock mode?
If your Kenwood Portable Radio is in Lock mode, press the [F] button for one second to switch it off.
How to turn off Tone Alert on Kenwood Portable Radio?
If the Tone Alert is active on your Kenwood Portable Radio, you can switch it off by pressing [F] and then [ENT].
How to disable CTCSS on Kenwood Portable Radio?
To switch off the CTCSS on your Kenwood Portable Radio, press [F], then [3].
How to stop Unnecessary Tone Alert on Kenwood TH-D7A Portable Radio?
To turn off the Tone Alert on your Kenwood Portable Radio when it remains active unnecessarily, press [F] and then [ENT].
How to exit Channel Display mode on Kenwood TH-D7A?
To exit Channel Display mode on your Kenwood Portable Radio, press [A/B] + POWER ON.
How to adjust volume balance on Kenwood TH-D7A Portable Radio?
To correctly adjust the volume balance between the two bands on your Kenwood Portable Radio, press [BAL], then [UP] or [DWN].
How to fix incorrect data input on Kenwood Portable Radio?
To ensure proper data input on your Kenwood Portable Radio, use Menu options 3–1 through 3–6 to correctly enter the desired information.
How to fix incorrect transfer rate settings on Kenwood TH-D7A Portable Radio?
Use the HBAUD command to select the appropriate transfer rate for your Kenwood Portable Radio.
General| Brand | Kenwood |
|---|---|
| Model | TH-D7A |
| Category | Portable Radio |
| Language | English |
Allows manual input of frequencies for radio operation.
Sets upper and lower frequency limits for tuning control.
Step-by-step guide for charging the NiCd battery pack.
Procedure for connecting the transceiver to a vehicle's cigarette lighter.
How to select between band A and band B for operation.
Methods for selecting a frequency using controls or keypad.
Steps for programming repeater offset frequencies and directions.
How to change the offset frequency for odd-split repeaters.
Guide to selecting the appropriate CTCSS tone frequency.
Configuration for the automatic repeater offset function.
Enabling and using the ASC function for direct contact.
Using the built-in TNC in Command and Converse modes.
Steps to prepare for remote control of the mobile transceiver.
Operating the Commander and Transporter in Sky Command mode.
Information required for technical or operational problem correspondence.
Diagrams for connecting external speakers, microphones, or TNCs.
To Next Page
