18 ADB_ADJ-BA-e-2032
9.3 Zeroing
In order to obtain optimal weighing results, reset to zero the balance before weighing.
Unload the balance.
Press the TARE key.
Wait until the zero display appears.
9.4 Sample weighing
Place the goods to be weighed and close the
windshield.
Wait for stability display .
Read weighing result.
Overload warning
Overloading exceeding the stated maximum load (max) of the device, minus
a possibly existing tare load, must be strictly avoided. This could damage the
instrument.
Exceeding the maximum load is indicated by the display „E “. Unload
weighing system or reduce preload.
9.5 Unit Conversion
By repeatedly pressing of the MODE key the weighed value can be switched over to
the available weighing and application units.
To Next Page
Loading...
Need help?
General
