KERN DS 8K0.05 - 7.2 Unpacking and Checking; 7.3 Assembling, Installation and Levelling

TDS-A-BA-e-2311 17
7.2 Unpacking and checking
Remove device and accessories from packaging, remove packaging material and in-
stall the device at the planned workplace. Check if that there has been no damage and
that all items of delivery scope are present.
Scope of delivery / serial accessories:
• Balance, see chap. 3.1
• Mains adapter
• Operating instructions
• Protective hood
7.3 Assembling, Installation and Levelling
 Remove the transportation lock, see chap. 7.3.1.
 Install weighing plate and wind shield if necessary.
 Ensure that the balance is installed in a level position.
 Level balance with foot screws until the air bubble of the water balance is in the
prescribed circle.
 Check levelling regularly