46 TDS-A-BA-e-2311
Procedure:
1. Define target quantity and tolerances
Make sure that the scale is in counting mode and that an
average piece weight has been defined (see chap. 11.2.1).
If necessary, switch over with the button.
Use the navigation keys to select the setting < tar-
get > and confirm with ➔ button.
< value > is displayed.
Confirm on ➔ button, the numeric input window appears.
The active digit is flashing.
Enter the target quantity (numerical input see chap. 3.2.2)
and confirm the entry.
The balance returns to the < value > menu.
Use the navigation keys to select the setting < Er-
rupp> and confirm on ➔ button.
Use the navigation keys to select the weighing unit and
confirm on ➔ button.
The numeric input window appears. The active digit is
flashing.
Enter the upper tolerance (for numerical input see chap.
3.2.2) and confirm the entry.
The balance returns to the < Errupp > menu.
To Next Page
Loading...
