6 YKB-01N-e-0921
6. Operating elements
After the power supply unit has been connected to the printer and the mains, and after
the
ON/OFF switch of the printer has been switched to “ON” position, the
red indicator for the power supply will light up.
This indicator also signals that the printer is ready for operation.
7. Start-up
⇒ On start-up press the FEED key; printer carries out self-test
and parameters will be printed.
Red LED is lit up, printer is ready for operation.
⇒ Press FEED key: Turn on/off date and time
⇒ Press and hold FEED: Paper will be transported
8. Storage conditions and use of thermal paper
Long-term usability of thermal paper is achieved by correct storage.
Storage:
- Dark storage location (no direct sunlight)
- Maximum relative air humidity 65%
- Maximum temperature 25°C
Always store printed paper under the following conditions:
- Do not expose to direct sunlight or intensive room lights
- Avoid contact with alcohol, solvents or similar substances (e. g. adhesives),
- Do not store inside PVC pockets
- Storage temperature < 25ºC.
9. Printer cable
To Next Page
Loading...
Need help?
General