Kernau KDI 4643 User Manual

EN
51
CHAPTER 9. TROUBLESHOOTING
TROUBLE
CODE
POSSIBLE FAULT WHAT TO DO
F5
Insufficientwater
Contact for service.
F3
Continuouswaterinput Closethetapandcontactforservice.
F2
Inabilitytodischargewater
Waterdischargehoseandfiltersmaybeclogged.
Canceltheprogram.Iftheerrorcontinues,
contactforservice.
F8
Heatererror Contactforservice.
F1
Overflow
Unplugthemachineandclosethetap.Contact
forservice.
FE
Faultyelectroniccard Contactforservice.
F7
Overheatingerror Contactforservice.
F6
Faultyheatersensor Contactforservice.
• The installation and repairing procedures should always carried out by the Authorised Service
Agent in order to avoid possible risks. The manufacturer shall not be held liable for damages that
may arise from procedures carried out by unauthorised persons. Repairs may be carried out by
technicians only. If a component has to be replaced, ensure that only original spare parts are used.
• Improper repairs or use of non-original spare parts may cause considerable damage and put the
user at considerable risk.
• Contact information for your customer service can be found on the back of this document.
• Function-relevant genuine spare parts according to the corresponding Ecodesign order
can be obtained from Customer Service for a period of at least 10 years from the date
on which your appliance was placed on the market within the European Economic Area.
Customer service
PL: +48 22 243 70 00
Mon 7:00 - 17:00
Tue-Fri 9:00 - 17:00
kontakt@kernau.com
HI
High voltage failure
Contactforservice.
LO
Low voltage failure
Contactforservice.
FF
Water inlet failure
Contact for service if the error continues..
Separate the inlet hose from the tap and clean
the filter of the hose.
Make sure the water inlet tap is open and water
is flowing.
F9
Divisor position error
Contactforservice.

Kernau KDI 4643 Specifications

General

Brand	Kernau
Model	KDI 4643
Category	Dishwasher
Language	English