NOTE: The floor plates are reinforced by the side profiles installed on the panels. Position
these side profiles so that they are inserted between the rubber stops on the side air
chambers.
7. Inflate the keel a little to lift the floor plates from the ground.
8. Attach the side profiles to the sides of the floor plates. Position the side profiles
between the rubber stops.
A - Paddle
B – Floor plates
C - Side joiner
MOUNT SEAT
➢ The seat must be attached before the boat is fully inflated. Inflat the boat about
three-quarters and insert the bench. Then inflate the boat fully.
PUMP
Valves
➢ The inflatable boat valves are specially designed for safe and convenient use. The
valves are designed flat to increase comfort in the boat and prevent damage to
the boat. Make sure the valve is tightly closed before using the boat.
Operation of the valve:
To Next Page
Loading...