Kestrel 4000 - Configuring Measurement Displays; Customizing Measurement Screen Visibility

Kestrel
®
4000 Pocket Weather
®
Tracker
Auto Store
(On/O)
When On, data is automatically stored at
preset Store Rate. When O, data is only
stored when manually captured with the
button.
Press or to toggle between
On and O.
Store Rate*
(2 sec – 12 hr)
The frequency at which data sets are
automatically stored. (Battery life may be
shortened if data is stored frequently.)
Press or to increase or
decrease Store Rate frequency.
Overwrite
(On/O)
This setting only applies when the data
log is full. When On, oldest data point is
discarded to allow memory for the new
data point. When O, new data points are
not saved.
Press or to toggle between
On and O.
Man Store
(On/O)
When On, data is stored when the
button is pressed. When o, the button is
disabled.
Press or to toggle between
On and O.
* When unit is o, data is NOT stored for 2 sec and 5 sec Store Rates.
Measurements
Measurement screens can be turned o, or “hidden” from the normal measurement navigation. For
example, if wind chill is not of interest, it can be hidden. Press the
or button to toggle between ON
and OFF for each individual measurement. Press the or button to highlight the desired measurement.
Press the button to return to the Main Setup Menu. Even when measurements are hidden, the Kestrel
Meter will continue to log data for all measurements. If you wish to see the logged data for measurements