Changed the Wah Wah 4 preset and changed the response curve on the volume
pedal in the case of an inserted Wah-Wah EFX.
Second Voice
From the main menu while holding down the 2nd Voice tab, you access directly the
second tone selection menu.
2
nd
Voice timbre remains until the main entry is changed.
To store it you need to enter the voice editing and save in a USER VOICE.
Midi reset
• A new MIDI RESET control has been included as part of MIDI reception (code:
F0 26 7B 39 05 00 F7).
• You can now change or select styles via MIDI IN (using Midi Keyboard RX part –
GLOBAL or RIGHT).
o Bank 40 – 49 is used to select the Factory style groups (Ballad = 40, Pop
= 41 etc.)
o Program Change (0 – 127) is used to select the factory style within the
selected style group. Max of 128 styles can be selected.
o Bank 50 – 59 is used to select the User style groups (Ballad = 50, Pop = 52
etc.)
o Program Change (0 – 127) is used to select the User style within the
selected style group. Max of 128 styles can be selected.
Octave CHORD1-5:
Added the capability to now change the octave of the Chords 1-5 in a style. In VIEW –
CHORD, you can now set the octave level of each chord (between -2 and +2).
Footswitch
• New programmable footswitch functions include Reintro, Set Down and Set up.
The Set down and Set up functions is used to switch between the 4 sets. This
means for an example that … even though you have a maximum of 13 functions
you can program onto the FS13 (or 6 for the FS6), you can program different
functions into the 4 sets and access each one for different performances,
meaning you now have access to 13 X4 (52 functions for FS13) or 6X4 (24
functions for FS6). So in Set 1, Footswitch #1 could be assigned to Start/Stop,
while in Set 2, Footswitch #1 could be assigned to SUSTAIN. By switching
between sets, you can now re-assign Footswitch #1 to up to 4 different
functions (determined by which set you are in).
To Next Page
Loading...
