1. Unpacking the Ultra - Model B50
Brewer
a. Carefully remove the Brewer by placing the box on
its side, and pulling the Brewer out of the box and
removing the protective materials.
b. Place the Brewer upright on a flat surface. Remove
three pieces of adhesive tape from Brewer.
c. Unwrap cord and plug Brewer into a grounded outlet.
2. Priming
a. Place a cup or mug on the Drip Tray Plate.
b. Remove the Water Reservoir from Brewer by first
removing Lid from Reservoir, then lifting Reservoir
straight up and away from Brewer. Rinse and fill
with cold water. Replace the Water Reservoir back
on the Brewer and replace the Lid.
c. Press Power Button to turn the Brewer on and the
green light will become illuminated.
d. The LCD Message Center will indicate ‘PRIME’ and
the Large Cup Icon will flash. Please note, a K-Cup
®
portion pack should not be used for the Priming
Sequence. If ‘PRIME’ does not display on the LCD
Message Center, ensure that the handle is pressed all
the way down.
e. Press the black button below the Large Cup Icon.
f. The Brewer will automatically fill (priming it) and
then the water will be heated. This will take about 3
minutes. During the heating period the ‘NOT READY’
indicator will be on. When the water is heated
‘READY’ will be displayed and the Large Cup icon
will flash.
g. Press the black button below the flashing Large Cup
Icon to start a cleansing brew, during which hot
water will flow into your cup or mug. Pour the hot
water into the sink.
h. The brewer may take 15 seconds to reheat between
brews and will display ‘NOT READY’. During this
time pump may cause a vibration noise. This is
normal. ‘READY’ will be displayed when the water
has reheated.
i. The one-time priming process is now complete and
you are ready to brew!
3. Choose
a. Place a cup or mug on the Drip Tray Plate.
b. Select a K-Cup
®
portion pack.
Do not remove the foil lid.
4. Brew
a. Lift the Handle, place the K-Cup in the K-Cup Holder
Assembly and then push the Handle all the way
down to puncture the K-Cup.
Please be careful to avoid the sharp needles in the
K-Cup Assembly Housing & Lid.
b. Select a brew size by pressing the black button
below the flashing Large or Small Cup Icon.
Quick Start Guide
Large
Cup
Button
Large Cup
Icon
PRIME
BREW
Large Cup (regular
7.25 oz serving)
Small Cup (stronger
5.25 oz serving)
NOTE: The smaller cup will brew stronger
tasting coffee/tea.
Let the Magic Begin FAST!
Thank you for purchasing a Keurig
®
Ultra - Model B50 Gourmet Single Cup Home
Brewing System.
IMPORTANT: You cannot use your Keurig brewer until it has been primed for its first use
as set forth below. Please follow these easy steps and you will discover what Deliciously
Simple
™
truly means.
Please note, if your Brewer has been exposed to temperatures below freezing, it is recommended you
allow two hours for an unpacked brewer to warm to room temperature before priming or brewing.
Please consult the Use & Care Guide for additional information on your Brewer. If you
are experiencing problems, contact Customer Service at 1-866-901-BREW (2739).
© 2005 Keurig Incorporated
MENU
To Next Page
Need help?
General
