STR
ONG
Remove packing tape from brewer.
Plug into an outlet.
Place a large mug (10oz minimum)
on the drip tray.
Remove the water reservoir lid, then lift the
reservoir straight up to remove it. If you have
a Keurig® Water Filter, install it now. Refer to
your Water Filter Starter Kit for instructions.
Rinse reservoir with fresh water and fill to the
MAX FILL line.
Replace water reservoir, making sure the tank
is seated properly in the base. Replace lid.
NOTE: Do not use distilled water.
Lift and lower the handle. Do not
insert a K-Cup® pod. The brewer will
power on automatically.
The 3 cup sizes will blink. Press the 8oz
button to start a cleansing brew. Pour the
hot water into the sink.
Do not remove the water reservoir or lift
the handle once the brew button has been
pressed until the brew has completed.
The one-time setup process is now complete
and you are ready to brew!
1
3
5
2
4
6
Before You Brew
Place a mug on the drip tray. If using a
travel mug, remove the drip tray and
place the mug on the drip tray base.
Lift the handle and place a K-Cup® pod
in the K-Cup® pod holder. Lower the
handle completely to close the lid.
Do not remove the foil lid on the
K-Cup® pod.
Plug & Place
Rinse & Fill
Lift & Lower
Cleansing Brew
Place Mug & Pod
Brew & Enjoy!
Brew Your First Cup
STR
ONG
The 3 brew sizes will blink. Select and
press your brew size. The light will
remain illuminated while brewing.
Brewing is complete when the sizes
are all illuminated. Lift the handle
and recycle the K-Cup® pod. (See
instructions below.)
CAUTION: While brewing, there is extremely hot water
in the K-Cup® pod holder. To avoid injury, do not lift the
handle during the brewing process.
Visit Keurig.com/Recyclable to learn more.
To Next Page
Loading...
Need help?
General
