Keurig K-SELECT - Before You Brew - Setup Steps; Plug and Place Brewer; Rinse and Fill Water Reservoir

Before You Brew
Rinse & Fill
Remove the water reservoir lid, then lift the reservoir
straight up to remove it.
If you have a Keurig® Water Filter, install it now. Refer
to your Water Filter Starter Kit for instructions.
Rinse reservoir with fresh water and fill to the
MAX fill line.
Replace water reservoir, making sure the lock tab
engages with the brewer. Replace lid.
NOTE: Do not use distilled water.
Plug & Place
Remove packing tape from brewer and plug into
a grounded outlet.
Place a large mug (12oz minimum) on the drip
tray plate.
Auto Off
Strong
Add Water
Clean
MAX.
Strong
Auto Off
Add Water
Descale
Auto Off
Strong
Add Water
Descale