8 9
UNPACKING INSTRUCTIONS
1
|
LET’S GET BREWING!
1. Place brewer box on a large steady surface (such as a table or
countertop) or on the floor. Open the box.
2. Remove enclosed literature.
3. Turn the box on its side with front of box face down.
4. Reach into the box and grasp the plastic bag that contains the brewer.
5. Carefully pull the plastic bag (and packaging materials) toward you
and out of the box. The brewer will still be encased in the polyfoam
and be on its side.
6. Remove the top polyfoam packaging material.
7. Carefully lift brewer off of the bottom polyfoam and place it upright
on a flat, steady surface.
8. Lift plastic bag off of brewer.
9. Record the serial number for this brewer on page 5 of this guide. The
serial number can be found on the bottom of the brewer box or on the
brewer behind the Drip Tray (when removed).
10. Place the brewer upright on a flat, steady surface. Remove tape
holding Water Reservoir in place.
We recommend you save all packing materials in case future shipping of
the product is necessary.
IMPORTANT: You cannot use your Keurig® brewer until it has been set up
for its first use.
NOTE: If brewer has been exposed to temperatures below freezing, allow
brewer at least two hours to reach room temperature before brewing.
A frozen or extremely cold brewer will not operate.
WARNING:
Keep all plastic bags away
from children.
To Next Page
Loading...
Need help?
General
