Need help?Do you have a question about the Key-Disp KD386 and is the answer not in the manual?
General| Brand | Key-Disp |
|---|---|
| Model | KD386 |
| Category | Bicycle Accessories |
| Language | English |
Identifies the specific model of the eBike display.
Details electrical, operational, and storage parameters of the display.
Visual representation of the display's physical dimensions and design.
Displays battery SOC, riding data like speed, ODO, TRIP.
Covers assist levels, push-assist, backlight, and error codes.
Includes parameter settings and restoring defaults.
Identifies key display elements like battery, speed, and power.
Explains the operation of the display's control buttons.
How to turn the e-bike system and display on and off.
Describes the sequence of data shown and how to cycle through it.
How to activate and use the push-assist feature.
Advises caution when using push-assist, especially when bike is stationary.
How to turn the e-bike headlight on and off.
How to select and adjust the motor assist levels.
Visual representation of battery charge levels.
How motor power output is shown on the digital display.
How error codes are displayed and what they signify.
How to navigate to the display's general settings menu.
How to reset trip distance, max speed, and average speed.
How to switch between Metric and Imperial units.
How to set the wheel diameter for accurate readings.
How to adjust the maximum speed limit of the e-bike.
How to select between 36V and 48V battery systems.
Details of voltage segments for system calibration.
How to configure battery SOC display (voltage vs. percentage).
How to adjust the sensitivity of the PAS sensor.
Configuration of different assist level modes.
Adjustment of assist level ratios for power output.
Setting the maximum current limit for the controller for performance.
Setting the number of magnets in the PAS sensor for pedal assist.
Configuration of speed sensor parameters for accurate speed measurement.
Adjusting the slow start-up behavior for smoother acceleration.
Adjusting the display's backlight brightness for visibility.
How to enable and set a power-on password for the display.
Steps for inputting and confirming the power-on password.
Procedure for changing an existing power-on password.
Entering a new password after a reset.
How to turn off the power-on password feature.
Resetting the display to its factory default configuration.
Information about the display's connection socket and pinout.
Explanation of the function of each wire in the connection socket.
List of error codes and their corresponding definitions.
Table showing default PAS ratio values for different assist levels.
Details of the product's warranty period and exclusions.
Crucial safety advice and operational warnings for using the display.
To Next Page
