motor to 100
//right
delay(2000);//define 2s
analogWrite(ML_PWM,0);//set the PWM control speed of left
motor to 0
analogWrite(MR_PWM,0);// set the PWM control speed of right
motor to 0
//stop
delay(2000);//define 2s
}//******************************************************************
Upload code successfully, the motors rotate faster.
Project 9: 8*16 LED Board
(1) Description
If we add a 8*16 LED board to the robot, it
will be amazing. Keyestudio's 8*16 dot
matrix can meet your requirements. You can
create facial emoticons, patterns or other interesting displays
yourself. 8*16 LED light board comes with 128 LEDs. The data of the
microprocessor (arduino) communicates with the AiP1640 through
the two-wire bus interface, so as to control the 128 LEDs on the
module, which produce the patterns you need on dot matrix. To
To Next Page
Loading...
