Series E4360 User’s Guide 5
In this Book
Specific chapters in this manual contain the following information:
Quick Reference – Chapter 1 is a quick reference section that helps
you quickly become familiar with your Keysight E4360 Modular Solar
Array Simulator (SAS).
Installation – Chapter 2 describes how to install your SAS. It
describes how to connect various loads to the output. It discusses
remote sensing as well as parallel and series operation.
Getting Started – Chapter 3 describes how to quickly get started
using the instrument in Fixed mode. This chapter also describes how
to configure the remote interface.
Using the SAS – Chapter 4 describes how to use the advanced
features of the instrument using the front panel menus and the
corresponding SCPI commands.
Specifications – Appendix A describes the SAS mainframe
characteristics and contains application information.
Using the Digital Port – Appendix B describes how to configure and
use the digital port on the back of the instrument.
SCPI Commands – Appendix C lists the SCPI programming
commands along with a short description of each.
Grouping/Compatibility – Appendix D describes output grouping
and compares the Keysight E4360 SAS and earlier Keysight SAS
instruments.
For complete details on the SCPI (Standard Commands for
Programmable Instruments) commands, refer to the Keysight 14360A
Programmer’s Reference Guide available at
http://www.keysight.com/find/E4360 under Technical Support
NOTE
You can contact Keysight Technologies at one of the following
telephone numbers for warranty, service, or technical support
information.
In the United States: (800) 829-4444
In Europe: 31 20 547 2111
In Japan: 0120-421-345
Or use our Web link for information on contacting Keysight in your
country or specific location: www.keysight.com/find/assist
Or contact your Keysight Technologies Representative.
The web contains the most up to date version of the manual. Go to
http://www.keysight.com/find/E4360 under Technical Support to get
the latest version of the manual.