Keysight Technologies FieldFox A Series

Keysight Technologies FieldFox A Series

756 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

412 Keysight N9927-90001 User’s Guide

On–the–Box Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option 233 on

N991xB), GPS (Option 307) and GPS Receiver (Option 307))

Troubleshooting

Table of Contents

Table of Contents7
- Overview23
- Preparing for Initial Use of Your New Fieldfox27
Cat (Cable and Antenna Test) Mode45
How to Make Dtf Measurements60
- DTF (Distance to Fault) Measurements How to Make DTF Measurements60
  - DTF Measurement Settings62
- TDR (Time Domain Reflectometry) - Option71
Table of Contents72
- TDR Measurement Settings74
Na (Network Analyzer) Mode85
- NA Mode Settings87
Time Domain - Option 010109
- Default Chapter110
  - Time Domain - Option 010110
    - Overview111
- Chapter 6 , “NA (Network Analyzer) Mode”, on Page 85112
Calibration for Na, Cat, and VVM Modes121
- Chapter 8, "Calibration for NA, CAT, and VVM Modes121
  - Calibration for NA, CAT, and VVM Modes122
  - SA (Spectrum Analyzer) Mode145
Table of Contents146
Table of Contents226
Display Lines (Sa Chapter) -"Display Line258
- About I/Q Analyzer (IQA) Measurements260
- I/Q Analyzer (IQA) Mode Settings261
  - How to Make Measurements Using the I/Q Analyzer Mode261
  - How to Capture I/Q Data to a File262
How to Modify the I/Q Data Measurement Parameters265
Alignments (Sa Chapter) - "Alignments286
- "Step 2: Select Trace Type" on Page 308305
- "Step 1. Connect Your Equipment" on Page352
Erta (Extended Range Transmission Analysis) Mode - Option 209499

Related product manuals

FieldFox N9914A

FieldFox N9915A

FieldFox N9917A

FieldFox N9918A

FieldFox N9952A

FieldFox N9938A

Preview: FieldFox N9912A

FieldFox N9912A

Preview: FieldFox B Series

FieldFox B Series

Preview: M937 A Series

Preview: M937 A PXIe Series

M937 A PXIe Series

Preview: Keysight Technologies B1505A

Keysight Technologies B1505A

Keysight Technologies 34923A