11
Getting Started
STEP 3. Install the Software
Software Installation Procedure
1. Install the Keysight IO Libraries Suite, using either the Keysight IO Libraries
Suite CD included with your shipment (CD part number E2094-60003), or
the downloadable file at www.keysight.com/find/iosuite. Follow the
installer prompts to install the IO libraries.
2. Install the network analyzer module software:
a. Using either the CD included with your shipment (CD part number
M9370-90003) or the downloadable file at
http://na.support.keysight.com/pxi/firmware, launch the installer.
b. Follow the installer prompts.
3. Complete the installation:
If Using an Embedded Controller:
a. After the InstallShield Wizard has completed, click Finish.
b. Restart the embedded controller PC, using Start > Restart, and wait for
the system to restart.
If Using a Remote Controller:
a. After the InstallShield Wizard has completed, click Finish.
b. Shut down the remote controller PC, using Start > Shut down.
c. Power down the chassis.
d. Power up the chassis.
e. Power up the remote controller PC.
NOTE Check for software updates at: http://na.support.keysight.com/pxi/firmware.
To Next Page
Loading...
Need help?
General
