Need help?Do you have a question about the Keysight Technologies B1500A and is the answer not in the manual?
General| Brand | Keysight Technologies |
|---|---|
| Model | B1500A |
| Category | Measuring Instruments |
| Language | English |
Includes part number, edition, and copyright details.
Covers warranty, technology licenses, and restricted rights.
Declares conformance with German noise regulations.
Declares Class A EMC suitability for professional use.
General safety precautions for operation, service, and repair.
Warning about hazardous voltage at measurement terminals.
Definitions for DC, AC, ground, and protective conductor terminals.
Definitions for Warning and Caution signs.
Safety rules for instrument power supply outputs.
Safety considerations for measuring high voltages and currents.
Explanation of protection circuitry and limits for safe operation.
Describes Force, Guard, Sense, and Circuit Common terminals.
Guidance on using the Guard terminal for leakage current reduction.
Use of 3-conductor AC cable and grounding.
Installation and connection of interlock circuits for safety.
Precautions before touching Force, Guard, and Sense terminals.
Compliance with WEEE directive and product disposal.
Handling and disposal information for perchlorate materials.
Details guarantee and support for Keysight B1500A.
Information on servicing and performing system recovery.
Notes on data backup and virus protection.
Definition, causes, and relationship of RSI to instrument use.
Recommendations for using mice and input devices ergonomically.
Lists the chapters and their content in the manual.
Overview of basic operations and required items.
Procedures for turning the B1500A on and off.
Steps to launch EasyEXPERT and manage workspaces.
Procedure for configuring the tracer test mode.
Steps to use the application test mode.
Steps to configure and use the classic test mode.
Steps to start and perform measurements.
How to set flags and remarks in the Test Result Editor.
Utilizing analysis functions in the Data Display window.
General description of the Keysight B1500A analyzer.
Overview of HRSMU, HPSMU, MPSMU, MCSMU, MFCMU, SPGU modules.
Overview of EasyEXPERT functions like measurement, analysis, and management.
Descriptions of Classic, Tracer, and Quick test modes.
Describes power, status indicators, display controls, and key controls.
Describes connectivity ports like GPIB, USB, LAN, and Interlock terminal.
Describes SPGU, WGFMU, SMU, CMU, and other modules.
Covers power, operating, storage, and installation requirements.
Steps for inspecting shipment and performing initial installation.
Step-by-step guide for initial instrument setup.
Configuration for GPIB address and system controller.
Describes how to install various accessories.
How to connect DUT to test fixture or connector plate.
How to compensate capacitance/conductance measurements using switching matrix.
Information on performing periodic maintenance, cleaning, and calibration.
Notices and information about plug-in modules.
Details hardware specifications including modules and conditions.
Conditions under which specifications are measured and verified.
Lists supported plug-in modules for the B1500A.
Details specifications for SMU modules like MPSMU/HRSMU.
Details specifications for the Multi Frequency CMU.
Details for SCUU and GSWU units.
Details for the High Voltage SPGU.
Details for WGFMU and RSU.
Overview of EasyEXPERT software features and modes.
General environmental, power, compliance, and dimension specifications.
Table listing accessories furnished with the B1500A.
Table listing available options for the B1500A.
To Next Page