Keysight B1500A User’s Guide, Ed ition 14 3- 7
Installation
Inspection and Installation
Inspection and Installation
This section describes what to do when you receive the instrument and accessories.
1. Inspect the shipment. See “To Inspect B1500 and Accessories”.
2. Verify the instrument operation and perform initial setup. See “To Perform
Initial Setup”.
3. Install the instrument in the appropriate place. See “Requirements” on page 3-4.
To use the instrument briefly, see “Getting Started” on page 1-1.
To change the Windows logon setting, see “To Change Windows Logon Setting” on
page 3-9.
To change the GPIB address of the instrument, see “To Change GPIB Address” on
page 3-10.
To allow the B1500A/EasyEXPERT to control external GPIB devices, see “To
Enable System Controller” on page 3-11.
To Inspect B1500 and Accessories
Perform the following inspections when the instrument and accessories arrive at
your site.
1. Before unpacking any components, inspect all boxes for any signs of damage
that might have occurred during shipment, such as:
•dents
• scratches
•cuts
• water marks
If you suspect any damage, notify your local Keysight Technologies sales or
service office.
2. When you open the boxes that contain the instrument and accessories, check the
components against the contents lists attached to the boxes.
If anything is missing, notify your local Keysight Technologies sales or service
office.
To Next Page
Loading...
Need help?
General
