-168, "Block data not allowed"
-170, "Expression error"
-171, "Invalid expression"
-178, "Expression data not allowed"
Execution Errors
-203, "Command protected; pulsed measurements require option 150"
-213, "INIT ignored"
-221, "Settings conflict"
-221, "Settings conflict; *TRG when TRIG:SOUR BUS not selected; trigger ignored"
-221, "Settings conflict; CALC:SCAL:REF 0.0 not compatible with CALC:SCAL:FUNC PCT|PPM|PPB;
CALC:SCAL:FUNC set to NULL"
-221, "Settings conflict; CALC:STATe or CALC:AVER:STATe OFF set"
-221, "Settings conflict; CALC2:TRAN:HIST:STATe OFF set"
-221, "Settings conflict; GATE:STAR:DEL:SOUR EVENts on channel 3; GATE:STAR:DEL:SOUR IMM set"
-221, "Settings conflict; GATE:STOP:HOLD:SOUR EVENts on channel 3; GATE:STOP:HOLD:SOUR TIM
set"
-221, "Settings conflict; ROSC:EXT:CHEC can only be sent when ROSC:SOUR EXT selectd;AUTO OFF set"
-221, "Settings conflict; SAMP:COUN limited to 100,000 in time stamp function with SENS:TST:RATE
SLOW; SAMP:COUN set to 100,000"
-221, "Settings conflict; SENS:FREQ:GATE:SOUR on measurement channel; SENS:FREQ:GATE:SOUR set
to EXT"
-221, "Settings conflict; SENS:FREQ:MODE CONT only valid for frequency/period; SENS:FREQ:MODE
AUTO set"
-221, "Settings conflict; SENS:GATE:EXT:SOUR on measurement channel; SENS:GATE:EXT:SOUR set to
EXT"
-221, "Settings conflict; SENS:TINT:GATE:SOUR on measurement channel; SENS:TINT:GATE:SOUR set to
EXT"
-221, "Settings conflict; SENS:TOT:GATE:SOUR on measurement channel; SENS:TOT:GATE:SOUR set to
EXT"
-221, "Settings conflict; cannot auto-level input channel used as gate; INP:LEV set to 0V, auto-level off"
-221, "Settings conflict; cannot delete state selected and enabled for automatic power-on recall"
-221, "Settings conflict; cannot gate time interval-type measurement with baseband channel;
SENS:GATE:EXT:SOUR set to BNC"
SCPI Error Messages
472 Keysight 53220A/53230A Programmer's Reference
To Next Page
Loading...
