M8100 Series Arbitrary Waveform Generators Getting Started Guide 41
Basic Setup for M8100A 2
Figure 15 Connecting M8008A clock generator to a single channel of M8198A AWG
Case 2 Connecting M8008A clock module to two channels on M8198A AWG
modules
In this case, an M8008A clock module, one M8198A AWG modules an
M9505A AXIe chassis and the following cables are required:
• 3.5 mm, 50 cm M8199A-811 customer orderable sync cable
(M8199-61620)
• 1.85 mm, 45 cm M8199A-810 replacement channel clock cable
(M8199-61624)
Make the connections as described below:
1 Connect the M8008A Clock Generator Sync Out port with the M8198A
AWG Sync In port using the sync cable (blue cable).
2 Connect the M8008A Clock Generator Sample Clock Out ports with
both the M8198A AWG Clock In ports for each Channel using clock
cable (red cable).
Figure 16 shows how to connect M8008A clock generator module to the
two channels of the M8198A AWG modules:
To Next Page
Loading...
