104 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
unleveled and *OPC? is executed. Since this query shall not return
0 ("not ready"; according to IEEE 488.2) the system will report an
execution error. If the unleveled or unlocked conditions are not
present, the error may suggest a hardware problem.
-184 Macro parameter error
A command inside the macro definition had the wrong number
or type of parameters.
-183 Invalid inside macro definition
The program message unit sequence, sent with a *DDT or a
*DMC command, is syntactically invalid (see IEEE 488.2,
10.7.6.3).
-181 Invalid outside macro definition
A macro parameter placeholder ($<number) was encountered
outside of a macro definition.
-180 Macro error
An error was encountered when defining a macro or executing a macro.
Specific details are not available.
-178 Expression data not allowed
A legal expression data was encountered, but was not allowed
by the device at this point in parsing.
-171 Invalid expression
To Next Page
Loading...
