Keysight X-Series Signal Generators Error Messages 109
Error Messages
List of Error Messages
The value of a header suffix attached to a program mnemonic
makes the header invalid.
-113 Undefined header
The header is syntactically correct, but it is undefined for
this specific device. For example, *XYZ is not defined for
any device.
-112 Program mnemonic too long
The header contains more than twelve characters (see IEEE
488.2, 7.6.1.4.1).
-111 Header separator error
A character that is not a legal header separator was encountered
while parsing the header.
-110 Command header error
An error was detected in the header. This message is used when
the device cannot detect the more specific errors described for
errors -111 through -119.
-109 Missing parameter
Fewer parameters were received than required for the header.
For example, the *ESE common command requires one parameter,
so receiving *ESE is not allowed.
-108 Parameter not allowed
To Next Page
Loading...
