24 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
-310 System error; Failed to write file.
An attempt to write to a file in the internal file system has
failed. This may be a temporary condition caused by insufficient
disk space or system interaction. Try reducing file system usage
and try again. If the problem persists, report this error to
service office.
-310 System error; FIR subsystem generated more coefficients than the
hardware can handle.
The maximum number of coefficients for a given set of hardware has
been exceeded. The filter must be created with fewer coefficients.
-310 System error; Hardware communication error during ramp sweep.
The synthesis system had a hardware communications failure during
ramp sweep.
-310 System error; Hardware error. Cause: {name}.
Generic hardware error occured. Specific cause given.
-310 System error; Hardware error. Unable to apply phase inversion!
There is an error with the baseband generator. Try turning CDMA2000
or 1xEVDV mode off and on again to reset the card. If the problem
persists, report this error to service office.
-310 System error; in {name} line:{value} file: {name} stack:{name}
To Next Page
Loading...
