Keysight X-Series Signal Generators Error Messages 23
Error Messages
List of Error Messages
-310 System error; Error updating RS232 RTS line. {name}
Caused by either framing, parity, or overrun errors during RS232
communication.
-310 System error; Exception report continued: {name}
An exception event (detailed in the {name}) has occurred on the
previous boot. If this error recurs after updating to the most
recent firmware, then the contents of this error message should be
reported to the nearest sales and service office.
-310 System error; Expected memory media not found. {name}.
Expected memory media (storage media) was not found. Report this
error to service office.
-310 System error; Failed to read from file.
An attempt to read from a file in the internal file system has
failed. This may be a temporary condition caused by insufficient
disk space or system interaction. Try reducing file system usage
and try again. If the problem persists, report this error to
service office.
-310 System error; Failed to start Application or CalTest harness.
A failure occurred when attempting to start the software module
responsible for digital modulation applications or calibration/self
test. Cycle the instrument's power. If this issue persists, please
reinstall firmware or report it to the service office.
To Next Page
Loading...
