26 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
An exception event (detailed in the {name}) has occurred on the
previous boot. If this error recurs after updating to the most
recent firmware, then the contents of this error message should be
reported to the nearest sales and service office.
-310 System error; Receive pace not supported
Command is not supported for RS232 communication.
-310 System error; Revert to default cal not implemented
Command not implemented.
-310 System error; Revision mismatch for RPC service {name}. Received
{value} but expected {value}.
The installed firmware components appear to be out of synch. Try
reinstalling the latest firmware package. If this issue persists,
please report it to the service office.
-310 System error; RS232 receive error. {name}
Caused by either framing, parity, or overrun errors during RS232
communication.
-310 System error; RS232 send error. {name}
Caused by either framing, parity, or overrun errors during RS232
communication.
-310 System error; RTS pace not supported
To Next Page
Loading...
