Keysight X-Series Signal Generators Error Messages 27
Error Messages
List of Error Messages
The RS232 command is not supported.
-310 System error; Sanitization failed. Device type = {name}, Error =
{value}.
A failure occurred during the sanitization of a device. Report this
error to service office.
-310 System error; Storage media not present: {name}.
Internal error. The storage media referenced was not found but was
expected. This could happen on a vector box when the internal USB
memory was not found during bootup.
-310 System error; The system was powered off during file system update.
File system volumes were verified.
Informational warning. Powering down system (turning the power off)
during file system write operation may leave the file system in
inconsistent state. On subsequent reboot the volume was verified
and errors repaired.
-310 System error; Transmit pace not supported
Command is not supported for RS232 communication.
-310 System error; Unexpected Analog FPGA overrange error on bit {value}.
Report this error to service office.
-310 System error; Unknown file system error. {name}
To Next Page
Loading...
