Keysight X-Series Signal Generators Error Messages 49
Error Messages
List of Error Messages
have 1601 points, for example. The {value} is the maximum number in
this case.
-223 Too much data; The number of points in the table exceeds the maximum
allowed.
This error occurs when you try to create a table that is too big.
For example, if you enter a list in SCPI that is longer than the
maximum allowed length, or if you attempt to expand a table and the
table is already at its maximum length.
-223 Too much data; The pulse train cannot be longer than {value} pulses,
including all repetitions.
The {value} is the maximum number in this case. Note that the last
repetition value is repeated as necessary if the on time or off
time lists are longer.
-223 Too much data; There can be no more than 256 unique waveforms in the
waveform list.
-223 Too much data; User filter has more than {value} symbols.
The baseband generator cannot use a filter that has more than the
specified number of symbols. You may have specified an incorrect
over-sample ratio in the filter table editor.
-223 Too much data; {name}
The specified file was being built up by a SCPI data block transfer
when the memory block allocation failed.
To Next Page
Loading...
