Keysight N5183B MXG - Data Out of Range Errors (-222) - Modulation and Channel Configuration; Modulation and Channel Configuration Range Errors

Keysight X-Series Signal Generators Error Messages 51
Error Messages
List of Error Messages
MEM:DATA:FSK commands for the differential states specification.
-222 Data out of range; A modulation must have at least two points.
Two points are needed to specify a 1 bit per symbol modulation.
This error can be reported for I/Q or FSK modulation specifications
using MEM:DATA:IQ and MEM:DATA:FSK.
-222 Data out of range; An FSK modulation can only have up to 16
frequencies.
The user has specified more than 16 frequencies in the MEM:DATA:FSK
command.
-222 Data out of range; An I/Q modulation can only have up to 256 states.
The user has specified more than 256 states in the MEM:DATA:IQ
command.
-222 Data out of range; Channel type not allowed for current link/config.
The channel type you are trying to add is not supported by the
current CDMA2000 or 1xEV-DV link and/or radio configuration.
-222 Data out of range; External reference bandwidth changed to narrow.
When setting the external reference frequency to anything other
than 10MHz the external reference bandwidth must be set in the low
or narrow setting. This warning is displayed when the the external
reference frequency causes the external reference bandwidth to be
changed from wide to narrow.