52 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
-222 Data out of range; In the {name}, the slot position + num_slots cannot
exceed 64.
The slot position + number of time slots cannot exceed 64. The slot
position will be clipped.
-222 Data out of range; M-Tone frequency range exceeds max limit. Table not
generated.
Either the frequency spacing is too large or the number of tones
are too many. As a result the maximum bandwidth of the IQ modulator
that produces the tones is exceeded. The M-Tone table can not be
generated untill the paramater settings are corrected.
-222 Data out of range; Manual point exceeds frequency list size. Limiting
to maximum point.
The sweep/list manual point has been reassigned to a smaller number
value due to the longest list decreasing in size or being turned
off. Its new value is the length of the frequency list that is the
longest enabled list.
-222 Data out of range; Manual point exceeds list sizes. Limiting to
maximum point.
The sweep/list manual point has been reassigned to a smaller number
value due to the longest list decreasing in size or being turned
off. Its new value is the length of the longest enabled list
(frequency or power).
-222 Data out of range; Manual point exceeds power list size. Limiting to
maximum point.
To Next Page
Loading...
