Keysight X-Series Signal Generators Error Messages 53
Error Messages
List of Error Messages
The sweep/list manual point has been reassigned to a smaller number
value due to the longest list decreasing in size or being turned
off. Its new value is the length of the power list, that is the
longest enabled list.
-222 Data out of range; Number of parameters is not an even number
The user flatness calibration points must be an even number.
-222 Data out of range; OCNS channel(s) power clipped to minimum limit.
As DPCH channel one power is increased, one or more of the OCNS
channels may become clipped to its minimum power of -40dBm during
channel balancing.
-222 Data out of range; Only DEFAULT or USER FILE data type is allowed.
Data type is changed to DEFAULT
Only Default data or user file is valid for Paging channel. Paging
data is now set to Default.
-222 Data out of range; Sequence point exceeds size of active lists.
Clipped to maximum list element.
An error that occurs when in list sweep mode. The index used for
determining the next point to sweep is beyond the valid range for
the current list of points.
-222 Data out of range; Synthesizer: Frequency out of bounds.
The signal generator received an internal request for a frequency
To Next Page
Loading...
