Keysight N9030B - Page 65

Table Of Contents
6.2.17 Signal ID Mode 2163
6.2.18 Cable IF Loss 2164
6.2.19 I/Q Path 2165
6.2.20 Reference Z 2167
6.2.21 I/Q Setup 2167
6.2.21.1 I Setup 2167
Differential 2167
Input Z 2168
Skew 2169
Combined Differential/Input Z (Remote Command Only) 2170
6.2.21.2 I Probe 2170
Attenuation 2171
Offset 2172
Coupling 2172
Clear Calibration 2173
6.2.21.3 Calibrate 2173
I/Q Isolation Calibration 2174
I/Q Isolation Calibration Time (Remote Query Only) 2175
I Port 2175
I Port Probe Calibration Time (Remote Query Only) 2175
I-bar Port 2176
I-bar Port Probe Calibration Time (Remote Query Only) 2176
6.2.21.4 Q Setup 2176
Q Same as I 2176
Differential 2177
Input Z 2178
Skew 2179
6.2.21.5 Q Probe 2179
Attenuation 2179
Offset 2180
Coupling 2180
Clear Calibration 2181
6.2.21.6 Calibrate 2181
Q Port 2182
Q Port Probe Calibration Time (Remote Query Only) 2182
Q-bar Port 2182
Q-bar Probe Calibration Time (Remote Query Only) 2183
6.2.22 I/Q Cable Calibrate 2183
6.2.22.1 I Port 2184
6.2.22.2 I-bar Port 2184
6.2.22.3 Q Port 2185
Vector Modulation Analyzer Mode User's &Programmer's Reference 65