Table Of Contents
Adjust Atten 450
Pre-Adjust for Min Clipping 451
Mech Atten Step 455
3.4.3.3 Range (Non-attenuator models) 456
Range 456
Adjust Range for Min Clipping 457
Pre-Adjust for Min Clipping 457
Peak-to-Average Ratio 458
Mixer Lvl Offset 459
3.4.3.4 Signal Path 459
Presel Center 459
Preselector Adjust 461
Internal Preamp 462
LNA 463
µW Path Control 465
Software Preselection 474
SW Preselection Type 475
SW Preselection BW 476
High Freq Prefilter 477
3.4.4 BW 478
3.4.4.1 Settings 478
Info BW 478
3.4.5 Display 479
3.4.5.1 View 479
View 479
User View 479
Restore Layout to Default 480
Save Layout as New View 480
Re-Save User View 481
Rename User View 481
Delete User View 481
Delete All User Views 482
View Editor Remote Commands 482
View Listing Query 482
User View Listing Query 483
3.4.5.2 Annotation 483
Graticule 483
Screen Annotation 484
Trace Annotation 484
Control Annotation 485
Meas Bar 485
Display Enable (Remote Command Only) 485
3.4.6 Frequency 487
3.4.6.1 Settings 487
Short Range Comms & IoT Mode User's &Programmer's Reference 15
To Next Page
Loading...
