Keysight N9030B - Page 32

Table Of Contents
Elec Atten 1046
Adjust Atten for Min Clipping 1050
Adjust Atten 1050
Pre-Adjust for Min Clipping 1051
Mech Atten Step 1055
3.8.13.3 Range (Non-attenuator models) 1056
Range 1056
Adjust Range for Min Clipping 1057
Pre-Adjust for Min Clipping 1057
Peak-to-Average Ratio 1058
Mixer Lvl Offset 1059
3.8.13.4 Signal Path 1059
Presel Center 1059
Preselector Adjust 1061
Internal Preamp 1062
LNA 1063
µW Path Control 1065
Software Preselection 1074
SW Preselection Type 1075
SW Preselection BW 1076
High Freq Prefilter 1077
3.8.14 BW 1078
3.8.14.1 Settings 1078
RBW Filter Type 1078
3.8.15 Display 1079
3.8.15.1 Meas Display 1079
Limit Lines 1079
3.8.15.2 Annotation 1080
Graticule 1080
Screen Annotation 1080
Trace Annotation 1081
Control Annotation 1081
Meas Bar 1082
Display Enable (Remote Command Only) 1082
3.8.15.3 View 1083
3.8.16 Frequency 1083
3.8.16.1 Settings 1084
Center Frequency 1084
CF Step 1089
3.8.17 Marker 1090
3.8.17.1 Select Marker 1090
3.8.17.2 Settings 1091
32 Short Range Comms & IoT Mode User's &Programmer's Reference