Keysight N9030B - Page 50

Table Of Contents
3.12.8 Meas Setup 1707
3.12.8.1 Settings 1707
Avg|Hold Num 1707
Averaging On/Off 1707
Average Mode 1708
Spur Avoidance 1708
Meas Setup Summary Table 1709
Auto Couple 1709
Meas Preset 1711
3.12.8.2 Meas Standard 1711
Radio Standard 1711
Preset to Std 1712
3.12.8.3 Advanced 1714
Noise Floor Extension 1714
Conversion 1716
Phase Noise Optimization 1717
3.12.8.4 Global 1717
Global Center Freq 1717
Global EMC Std 1718
Restore Defaults 1719
3.12.9 Sweep 1719
3.12.9.1 Sweep/Control 1719
Sweep Time 1719
Minimum Acquisition Time 1721
Sweep/Measure 1722
Restart 1724
Pause/Resume 1727
Abort (Remote Command Only) 1727
Sweep Time Annotation (Remote Query Only) 1728
3.12.9.2 Sweep Config 1728
Points 1728
3.12.10 Trace 1730
3.12.10.1 Select Trace 1730
3.12.10.2 Trace Control 1730
Trace Type 1731
Clear and Write | Restart Averaging | Restart Max/Min Hold 1736
View/Blank 1736
Trace Settings Table 1739
Clear All Traces 1739
3.12.10.3 Detector 1739
Detector 1739
Detector Select Auto/Man 1741
50 Short Range Comms & IoT Mode User's &Programmer's Reference